Main components of a disc brake

Mar 08, 2026

Leave a message

Brake Disc
Brake Disc Diameter
The brake disc diameter D should be as large as possible. This increases the effective radius of the brake disc, reducing the clamping force of the brake caliper and decreasing the unit pressure and operating temperature of the brake pads. Due to the limitation of the wheel rim diameter, the brake disc diameter is usually chosen to be 70%-79% of the wheel rim diameter. For vehicles with a total mass greater than 2 tons, the upper limit should be used.

 

Brake Disc Thickness
Brake disc thickness affects the brake disc's mass and temperature rise during operation. To reduce mass, the brake disc thickness should not be too large; to reduce temperature, the brake disc thickness should not be too small. Brake discs can be made solid, or ventilation channels can be cast in the center of the brake disc for heat dissipation and ventilation. Generally, the thickness of a solid brake disc is 10-20 mm, and the thickness of a ventilated brake disc is 20-50 mm, with 20-30 mm being the most common. During emergency braking at high speeds, the brake disc will undergo thermal deformation, causing vibration. To improve the heat dissipation performance of the brake disc friction surface, most brake discs are designed as ventilated discs with a central cavity, which can reduce the brake disc temperature by 20% to 30%.

 

Friction Liners: Friction linings are the friction materials that the caliper piston pushes against the brake disc. Friction linings consist of friction material and a base plate, which are directly pressed together.

 

The ratio of the outer radius to the inner radius of the friction lining is recommended to be no greater than 1.5. If this ratio is too large, the difference in circumferential speed between the outer and inner edges of the lining during operation will be significant, resulting in uneven wear, reduced contact area, and ultimately, large variations in braking torque.

 

For the working area A of the disc brake lining, it is recommended to select a lining area within the range of 1.6 to 3.5 kg/cm², based on the vehicle mass occupied by the brake lining unit area.

 

The brake disc is made of alloy steel and fixed to the wheel, rotating with it. The brake caliper is fixed to the base plate of the brake and remains stationary. The two friction pads on the brake caliper are mounted on both sides of the brake disc. The piston of the brake caliper is driven by the hydraulic pressure delivered by the oil pipe, which pushes the friction pads against the brake disc to generate friction braking. The action is like using pliers to clamp a rotating disc and force it to stop.

Send Inquiry